Service Engineer
Stellapps · Palamaner
Source and collection record
Last observed by our collector: . This is not a manual review or a confirmation from the employer.
Job type and experience labels are automated discovery categories. The employer determines eligibility. Original experience wording was not retained separately; check the current employer page.
Your application evidence checklist
Mark the statements you can support after reading the employer source. This checklist stays on this page; it does not score your eligibility or submit an application.
0 of 3 checks marked. Keep unresolved requirements as questions for the employer.
Collected role description
2+years of experience in PCB Analyzing and repair and Hands-on experience in soldering & de-soldering of all types of components Qualification: Diploma E&C or B.E E&C Job Description: PCB Analyzing and repair. Hands-on experience in soldering & de-soldering of all types of components. Able to understand electronic schematic & data sheets. Analyzing the cause of failure and repairing the faulty parts. Testing and troubleshooting electronic circuits. Testing and troubleshooting of rectifiers, amplifiers & sensors. Familiar with basic test equipments like CRO, function generators, DVM & tools. Knowldge in ADC, UART, Wifi, Bluetooth, GSM AT commands and Zigbee. Porting/flashing of software, Basic knowldge in programing and linux commands Good communication skill. Travel 40-50% Knowledge: Indepth knowldge in electronic components Linux OS C Programming MS Office / Libro Office Roles and Responsibilities: The candidate’s primary responsibility will be servicing the faulty materials within SLA. Service Report preparation. Daily status Report and Monthly service reports preparation. Repeated failure analysis report preparation. The candidate shall be ready to travel on a requirement basis. The responsibility will also be considered not to share or disclose any of the confidential data such as circuit diagrams, software etc. The candidate shall be responsible for the entire service equipment and tools.
Collected minimum qualification
Diploma E&C or B.E E&C
Collected experience requirement
2-3 Years